Installation Tips
   Simple "Perfect Fit" Installation

We make it simple to install your Lenape Bathware with a perfect fit every time. Just locate the desired position of the piece on your wall using the included clips as a guide. After marking the location of the clip holes, drill pilot holes with a 1/4 " bit. On drywall, insert the included plastic anchors into the pilot holes. Attach the clips to the anchors with the provided screws, making sure that the arrow points up. Lastly, slide the item down onto the clip and you are finished!

-Installation on other surfaces may require a different type of anchor.
-Use a "Glass and Tile" drill bit if you are installing your bathware over tile.

When installing a two piece assembly, you must carefully measure between the clips to ensure a snug towel bar or paper roller.

From center to center of the clips, the standard measurements are:

Carrousel Paper Holder	5-5/8"
Carrousel Towel Bar	24"
Classic Towel Bar	24"
Classic Double Towel Bar	24"

Use the towel bar itself as a template. The clips install at the same distance as the length of the bar. You can easily reduce the size of the towel bar assembly by shortening the bar with a hacksaw. Use the shortened bar as the template.

Professional Series

Professional series accessories are installed using a construction grade plastic such as "Liquid Nails for Remodeling". Follow the directions on the tube. The adhesive is applied to the entire back surface of the piece and mounted directly to the sheetrock or tile backer board. The Professional series is designed to be installed with ceramic tile. The item would be installed in-place of a piece or pieces of tile. Grout the gap with tile grout then seal with waterproof caulk.

Re-Place-A-Bars

Use a hacksaw to cut your old towel bar in two pieces so you can remove it. You do not have to remove your towel posts!

Press the end of the Re-Place-A-Bar into the hole of one post to compress the spring. Measure and mark the free end of the bar so the other end-piece will just slide into its hole. Remove the end-piece and cut the bar with a fine tooth saw.

Reinsert the end-piece. Compress and insert the Re-Place-A-Bar into your towel bar posts. It will now rest firmly in place!

<return to top>